Setting the maximum charging current
| The tasks described in this section may only be carried out by a qualified electrician. |
The maximum charging current of the charging point can be set via DIP switches 1, 2 and 3 on bank S2.
The maximum charging current can be set to 6 A, 10 A, 13 A, 16 A, 20 A, 25 A or 32 A.
DIP switch setting (bank S2) | Max. charging current [A] | ||
|---|---|---|---|
1 | 2 | 3 | |
OFF | OFF | OFF | 32 |
ON | OFF | OFF | 25 |
OFF | ON | OFF | 20 |
ON | ON | OFF | 16 |
OFF | OFF | ON | 13 |
ON | OFF | ON | 10 |
OFF | ON | ON | 6 |
The settings ON – ON – ON are invalid for configuring the maximum charging current (LED “Fault” lights up). If these settings are selected, a new master RFID card can be programmed (“taught”).