Intended use
The product is intended for use in semi-public and public areas.
The product is intended exclusively for the charging of electric and hybrid vehicles, hereinafter referred to as “vehicle”.
- Charging according to Mode 3 pursuant to IEC 61851 for vehicles with non-gassing batteries.
- Plugs and sockets according to IEC 62196.
Vehicles with gassing batteries cannot be charged.
The product is solely intended for stationary, base-mounted outdoor installation.
In some countries, there is a requirement for a mechanical switching element to disconnect the charging point from the mains if a load contact on the product is welded (welding detection). The requirement can be implemented, for example, by means of a shunt release.
Legal requirements in some countries provide for additional protection against electric shock. One possible additional protective measure is the use of a shutter.
The product may only be operated taking into account all international and national regulations. Observe the following international regulations or the respective national transposition:
- IEC 61851-1
- IEC 62196-1
- IEC 60364-7-722
- IEC 61439-7
When delivered, the product meets the minimum requirements of the European standards for charging point identification in accordance with EN 17186. Some countries have additional national requirements, which must also be observed.
Read, observe and retain this document and all additional documents for this product and, if necessary, pass them on to the subsequent operator.